Question

Ex. 3 Fill in the gaps with the compounds from ex.2
Starting the machinery
1. Turn on cooling ................................. through the condenser.
2. Open the compressor ........................................on discharge and suction sides. There must be free passage between compressor, condenser and receiver.
3. At the ...................................open the correct gas and liquid valves for the evaporators that are to be in service. Check that the other valves at the valve station are closed.
4. Before starting, the compressor should be turned over a few times by hand so that oil reaches ......................................, particularly if the machinery has been idle for a long time. If the compressor is fitted with ..........................................., this should be employed to simplify starting.
5. Start the fans for ........................................... (and brine pumps where applicable).
6. Start the compressor or compressors.
7. If knocking is heard in the compressor, stop immediately and restart after a minute or two.
Repeat if necessary.
8. Check the evaporation and condensation pressures, ................................................. and
............................................. If the oil pressure fails to rise within a couple of minutes, restart with intervals to get possible .........................................................................in oil evaporated.
9. Regulate the ......................................................... to between +25oC and +40oC by adjusting the flow of cooling water to the compressor oil cooler.

Answer 1

Ответ:

1)expensive

2)faster

3) tham smoller

4